Sherline 2000 CNC Mill

[cooliced]

Yeah, looking over the Sherline website, they do a 10k spindle pully set..im not sure wether it would reduce the power...

Ive kind took a back seat until i can get a probe setup, i keep finding myself getting fustrated that my cuts are sometimes off.

Altho i do have another video to post.

thanks for looking

Stu

[Jonathan]

Those are far too shiny. Did you just use a buffing wheel to polish them? The finish looks very even in the video.

they do a 10k spindle pully set..im not sure wether it would reduce the power...

If the pulleys just change the ratio of the existing motor then you will have the same power (minus a fraction for reduced efficiency) at 10k, but proportionately less torque as Power=torque*angular velocity.