Driver Lights Red

[Jonathan]

Motors-SY60STH86
Wiring setup,black/white n green/white together B-
black n green together B+
red/white n blue/white together A-
red n white together A+

That's wrong... you've got one coil on each phase backwards.

• B- Green--Black/white
• B+ Black--Green/white
• A- Yellow--Red/white
• A+ Red--Yellow/white

Lucky your drivers are protected against wiring wrong!

I'll post about the breakout board later if you need it... hopefully it'll all work once the wiring is sorted.
Basically you look on the breakout board manual for which axis each pin is set to and enter those in the ports and pins setup in mach3. Then set the E-stop pin on the inputs tab otherwise nothing will work...