. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 20-11-2011 #3
    JAZZCNC's Avatar
    Lives in wakefield, United Kingdom.
    JAZZCNC
    Last Activity: 19-01-2024 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 8,446. Received thanks 1,445 times, giving thanks to others 109 times.
    What a shit manuel that is why bother.?

    Anyway to answer your Q just put one of the wires from the E-stop to any input connection then the other wire to Ground connection. Then in the control software IE Mach just assign that input number to the E-stop input option in ports n pins setup.

    Edit: Regards Switch being wired 2 ways it will be either normally open (NO) or normally closed (NC) wire it NC. If your using Mach and it won't reset or doesn't come out of E-stop then just toggle the active hi-lo setting in ports n pins.
    Last edited by JAZZCNC; 20-11-2011 at 10:28 PM.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to JAZZCNC For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help with Mach 3 REF all Home Button
    By Kevin1970 in forum Artsoft Mach (3 & 4)
    Replies: 11
    Last Post: 23-04-2015, 10:54 AM
  2. Mach3 Using a physical button to repeat current gcode
    By RLKS Rob in forum Artsoft Mach (3 & 4)
    Replies: 2
    Last Post: 12-08-2012, 01:30 PM
  3. Donate Button
    By Ricardoco in forum General Discussion
    Replies: 8
    Last Post: 08-09-2011, 10:32 PM
  4. Machine co-ordinates button in Mach 3
    By alan2525 in forum Artsoft Mach (3 & 4)
    Replies: 1
    Last Post: 14-04-2010, 10:57 PM
  5. Wiring in power and E-stop on DIYCNC Board
    By m.marino in forum General Electronics
    Replies: 2
    Last Post: 10-05-2009, 10:15 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules