Any one used drivers and steppers from CNC4you

[Gary]

Mark,
Didnt see any email from you.
Call me on 01202 237770 or email me on [email protected]
Check to see if the FSI type nut will fit before butchering the ballnut.
the dimensions are on our website under the gten brand of ballscrews.

[Gary]

Didnt look at the link, just googled the mill.
you can use 3nm motors on the X and Y and a midle size nema 34 on the Z, but, if you can fit smaller nema 34 on the X and Y, i would think it would be better.
you can also gear the X and Y with a 2:1 as well if using a 3nm motor
This will add to the resolution and give you a but more grunt as well.

[sebring115]

Email on its way, thanks for the help in advance!

[cooliced]

Gary,

As above, im also looking at this mill with cnc setup, what would be your price for a bundled kit to do this conversion.

Cheers

Stu

[Gary]

there are a number of ways to do the conversion.
Call me at work on 01202 237770

Gary,

As above, im also looking at this mill with cnc setup, what would be your price for a bundled kit to do this conversion.

Cheers

Stu