Thread: fly cutter advice please
-
04-12-2011 #11
Done that a few times for the same reason. Now I just use a bar I machined to 80mm as a gauge, but still it's best to use an actual spindle as then I can get the mounts level using surface plate etc..
:cry: Have you done anything with the drive since? I've fixed a VFD in which some of the IGBTs and other bits blew on before now, so you never know...worth a try as they're not cheap?
Could you link me to that one to confirm which it is please? What's the run-out like?
Useful ... better than the other pics I've seen. I've been contemplating modifying one for ATC, but never wanted to risk taking mine apart. Now the rotor/collet chuck is out it should be possible to machine it accordingly.
Thought about trying to rewind the spindle? If it was me I'd have a go. Nothing to loose.
-
06-12-2014 #12
-
06-12-2014 #13
-
07-12-2014 #14
Weve just fixed two vfd's off a shear. There 3phase ones but still cheaper than buying a brand new one
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
Polystyrene Cutter
By kingcreaky in forum Marketplace DiscussionReplies: 2Last Post: 12-05-2014, 08:44 PM -
Cutter question
By SimonH in forum Machine DiscussionReplies: 2Last Post: 12-02-2013, 05:50 PM -
Which Plasma Cutter to buy?
By AndyG in forum General DiscussionReplies: 7Last Post: 02-12-2011, 09:34 AM -
cutter for MDF
By deannos in forum Tool & Tooling TechnologyReplies: 5Last Post: 16-10-2011, 09:33 PM -
First Plasma Cutter
By antsals in forum Plasma Table MachinesReplies: 3Last Post: 16-05-2011, 07:58 AM
Bookmarks