. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-12-2011 #1
    deannos's Avatar
    Lives in LONDON, United Kingdom.
    deannos
    Last Activity: 28-12-2018 Has been a member for 9-10 years. Has a total post count of 155. Received thanks 2 times, giving thanks to others 29 times.
    I'm using Mach3 and i'm trying to tune the motors. Can some one explain in simple terms the way to do this please. I'm lost with micro stepping etc.

    I'm using the following-

    3 X Stepper motors (M60STH88-3008DF)
    3 X Microstepping Drives - (MSD542)

    2 x screws-m12 x 1.75mm
    1 x screw - m16 x 2mm

    On the drives the microsteps pins are set to
    8 -microsteps/full steps
    1600 -microsteps/rev

    should i set the microsteps differently

    Thanks
    Dean
    Last edited by deannos; 05-12-2011 at 11:49 AM.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Mach 3 using laptop and usb
    By drftnr34 in forum Motor Drivers & Controllers
    Replies: 6
    Last Post: 09-07-2015, 04:38 PM
  2. NCStudio or Mach 3 or something else?
    By Fivetide in forum Machine Control Software
    Replies: 7
    Last Post: 01-09-2012, 05:41 PM
  3. mach 3 help
    By 1albobs in forum Artsoft Mach (3 & 4)
    Replies: 3
    Last Post: 27-02-2012, 03:34 PM
  4. Does Mach 3 run ok on laptops?
    By I need a dog in forum Artsoft Mach (3 & 4)
    Replies: 10
    Last Post: 09-12-2009, 11:07 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules