. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 05-12-2011 #3
    Jonathan's Avatar
    Lives in Leicester (Home) or Nottingham University (2nd Home), United Kingdom.
    Jonathan
    Last Activity: 05-04-2020 Forum Superstar, has done so much to help others, they deserve a medal. Has been a member for 9-10 years. Has a total post count of 3,571. Received thanks 325 times, giving thanks to others 8 times. Referred 1 members to the community.
    Though it is good to use the microstepping value you have chosen for smooth running it may limit your feedrate if the kernel frequency in Mach3 cannot be set high enough. In which case lower the microstep resolution. For instance with the 2mm pitch screw and Mach3 on the standard 25kHz with 1600step/rev you get 25000/1600*2*60=1875mm/min maximum.
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to Jonathan For This Useful Post:

« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Mach 3 using laptop and usb
    By drftnr34 in forum Motor Drivers & Controllers
    Replies: 6
    Last Post: 09-07-2015, 04:38 PM
  2. NCStudio or Mach 3 or something else?
    By Fivetide in forum Machine Control Software
    Replies: 7
    Last Post: 01-09-2012, 05:41 PM
  3. mach 3 help
    By 1albobs in forum Artsoft Mach (3 & 4)
    Replies: 3
    Last Post: 27-02-2012, 03:34 PM
  4. Does Mach 3 run ok on laptops?
    By I need a dog in forum Artsoft Mach (3 & 4)
    Replies: 10
    Last Post: 09-12-2009, 11:07 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules