Thread: ATX cycling fault?
Threaded View
-
07-12-2011 #1
I've just dragged an old ATX type Dell out of the cupboard with the intent on getting it ready to use with Mach 3.
It's doing something weird, about 3 seconds after applying mains power it stops and restarts.. I've tried disconnecting all drives etc, everything but the motherboard, it still does it.. The fan on the power supply is stopping and starting at the same times. I'm thinking the power supply has died, there's no fancy motherboard sensing stuff in an ATX power supply is there? Any thoughts most welcome!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Plasma cutting fault diagnoses....
By Davek0974 in forum Plasma Table MachinesReplies: 15Last Post: 01-04-2014, 07:04 PM -
heidenhain vrz731b fault
By p.cage in forum General ElectronicsReplies: 0Last Post: 31-01-2014, 03:56 PM -
Servo fault handling
By m_c in forum Motor Drivers & ControllersReplies: 0Last Post: 23-09-2013, 04:39 PM -
Heidenhain DRO fault
By Lancer in forum General ElectronicsReplies: 5Last Post: 29-06-2012, 09:57 AM -
Denford Triac Spindle Fault
By Sam_Smith in forum Denford MillsReplies: 5Last Post: 04-05-2011, 11:07 PM
Bookmarks