Hewing hall millgrav

[John S]

That's the one I have Jonathan, the 2300A, also picked up the matching mill, a PNC3100, jogs but won't run a program.

That's going the same way, gut and transplant, waiting for a batch of driver boards from china.

[Jonathan]

That's the one I have Jonathan, the 2300A

What program have you tried to run it? We ran it just via Techsoft 2D Design V2. You just drew the part, drew contours for the toolpath and assigned different tools and depths to different colour lines. Then just print to the 2300.. I thought it was quite good since as you're actually drawing the toolpaths you have full control, easy to use system (though hard to do anything other than 2.5D).

(any news on those rails?)