Hewing hall millgrav

[Swarfing]

Mill Grav

Roger may not see your reply so i will give him a knudge for you

[Archersigns]

Good afternoon All
We have 3 millgrav in our business and have been running them for nearly 2 decades from the JLS software,
We have decided to upgrade the software and are going for CADLINKS engraving lab but we seem to be hitting various issues when handshaking the apex controllers we have both 2 key anf 3 key versions
any help would be appreciated if some has some experience of this I really dont want to flash the Apex controller as if it doesnt work their scrap and getting the firmware again is nowon impossible except from pantograph in leeds
like I said any help would be appreciated

[milesinfront]

Good afternoon All
We have 3 millgrav in our business and have been running them for nearly 2 decades from the JLS software,
We have decided to upgrade the software and are going for CADLINKS engraving lab but we seem to be hitting various issues when handshaking the apex controllers we have both 2 key anf 3 key versions
any help would be appreciated if some has some experience of this I really dont want to flash the Apex controller as if it doesnt work their scrap and getting the firmware again is nowon impossible except from pantograph in leeds
like I said any help would be appreciated

I'm triple jealous! You have 3 times more MillGrav in your life than I... ;)

These guys are the original manufacturers of the Apex controllers: www.irridianindustrial.co.uk

They should be able to advise if what you want to achieve is possible.

Please let us know how you go. I'm happy enough with JLS but I do have EngraveLab and could be useful alternative. :)

[JAZZCNC]

any help would be appreciated if some has some experience of this I really dont want to flash the Apex controller as if it doesnt work their scrap and getting the firmware again is nowon impossible except from pantograph in leeds

The folks at Pantograph are the most helpful company I've ever had the pleasure to deal with, I would speak to them about this.
I was there a few weeks ago regards a Router/engraver I've got to build and they freely allowed me to pick their brains and vast knowledge regards engraving machines. They showed me around the whole place and spent best part of 2 hours offering advice and making suggestions knowing full well the only business they were likely to get was for a £130 engraving spindle. They really are Genuine helpful people who want to help and they have forgotten more than most so-called experts think they now about engraving and it instantly shows when you meet and speak to them.