I just got this....what is it?

[Swarfing]

The drivers look like 'Pacific' maybe?, two relays on the bob? You will need to check output of the PS to find out what voltage the steppers are running at? maybe 1.4 to 2 amp steppers? can not say without a few more pics?

Certainly looks like a good place to get into cnc routing though so good start i would say :-)

[AndrewD]

Finally got some time to have a crack with this router.

Loaded Mach3 demo onto a PC and managed to get it on the right port etc, I can trigger test the end-stops etc, ran into a problem with the reset switch always on but found an active E-stop trigger so got that disabled.

All I wanted to do is 'JOG' the motors but with a sample code in I had a few twitches from the bed but that was all.

How do I know what pins are what on this as it has not instructions etc?