Design Help Pt2 Required for CNC design/Build

[routercnc]

The vertical plate on the back of the Z axis (to which the Y axis ballscrew is attached) is trapped between the small top and bottom plates. This means it needs to be machined accurately to ensure the Y axis bearings sit correctly. It would be better to make this plate full height and have narrower top and bottom plates so that everything can be set before tightening the bolts.

[MikeyC38]

Thanks Jazzcnc, Jonathan and routercnc for the comments on the Y and Z axis. Re-design in process to include using smaller seperate extrusions to reduce
alignment issues and enable the Y axis ballscrew and nut to be located under the Y axis rails and reduce the distance to the Z axis assembly.

Talking about the alignment of the axes for a CNC, I had the idea to buy a large thick piece of float glass (10mm x 1500 x 1000) to provide my "flat" surface from
which I could then make accurate measurements using a dial micrometer. By measuring the surface first, one could reasonably then account for the variations in the surface when measuring...

Regards
Mike

[MikeyC38]

Hi Guys

Been busy at work but have re-worked the Y-axis gantry design, taking into account all your comments. Have shifted the Y axis ballscrew closer to the Z axis gantry and used seperate extrusions to allow this and maintain torsional stiffness I think. I guess the main issue is the use of supported round rails - profiled rails would reduce the height and thickness. However given my other constraints of time, budget etc..lets see. The other approach is to use the extrusions in a L-shape as per Jazzcnc's photos. This has the advantage of mounting the BF and BK blocks on the Y-axis and not having to cut the rails. Will probably work up that design as well and make a decision. Now I just need some more money for the ali, steppers and electronics!

Regards
Mike

[MikeyC38]

Hi Guys

Been busy at work but have re-worked the Y-axis gantry design, taking into account all your comments. Have shifted the Y axis ballscrew closer to the Z axis gantry and used seperate extrusions to allow this and maintain torsional stiffness I think. I guess the main issue is the use of supported round rails - profiled rails would reduce the height and thickness. However given my other constraints of time, budget etc..lets see. The other approach is to use the extrusions in a L-shape as per Jazzcnc's photos. This has the advantage of mounting the BF and BK blocks on the Y-axis and not having to cut the rails. Will probably work up that design as well and make a decision. Now I just need some more money for the ali, steppers and electronics!

Regards
Mike

Well finally after all this time, I plan to start my build in August. Attached is the final design. I got all the bits now (Plate, extrusion, Zapp Stepper kit 1, ballscrews) so watch the build log for pics and progress. Again many thanks to all especially Jazz for the redesign. Here goes!