wall and floor fixing am I the only one ????????????

[JAZZCNC]

It looks like you have been worrying about this for a long time (since 2007)

It took that long for the coins super glue to dry. .

Looks like your worring about nothing there James.!! . . . Crank up the Accelleration/velocity and lets see it. Edit: Preferably cutting.

On another note.!. . . Are you going to lift those spindle brackets further up the front plate, basicly so the collet just clears the bottom of plate so your not wasting clearence height.?

[Jonathan]

Looks like your worring about nothing there James.!!

Now it is fixed down, yes that's shown there's nothing to worry about.

On another note.!. . . Are you going to lift those spindle brackets further up the front plate, basicly so the collet just clears the bottom of plate so your not wasting clearence height.?

Don't see the point as the height of the bed is adjustable, and doing that would mean the Z-axis would generally operate further down, which is weaker unless you compensate by putting the bed higher but I suspect it is already at the limit? Also if the collet just clearly the Z-axis could get in the way/collide with a large 3D part when cutting low down.

[JAZZCNC]

Don't see the point as the height of the bed is adjustable, and doing that would mean the Z-axis would generally operate further down

Ah ah thought it was strange having all that Z axis travel and so little clearence didn't know the bed was adjustable, doesn't look it from the Vid. I should probably payed more attention to the rest of the thread!! . . . . ME BAD.:confused: . . In that case forget what I said.:rofl: