How anti social!

[Web Goblin]

Nice work Jonathan. What did you generate the code with?

Ian

[Jonathan]

Nice work Jonathan. What did you generate the code with?

Vectric V-carve, except it wasn't me. Jazz kindly gave me the code which saved a lot of time! :tup:

So if I'm reading it correctly, I'v egot until Dec 21st to find my spare Kress :-)

Yes, ideally a bit before then.

Given the interest in this it looks like I forgot to post it on the forum at the time!

[JAZZCNC]

Vectric V-carve, except it wasn't me. Jazz kindly gave me the code which saved a lot of time! :tup:

It was actually done im Artcam pro not vectric V-carve.! If anyone wants the code there welcome to it but it's a 17mb file and over 1 million lines of code.
PM me with email and I'll send.

Ian, (Web Goblin)
The guy who gave me these dxf's(Carve0ne on cnczone) was cutting quite large disc's in mdf and oak. I wanted to cut 150mm in Ali so the dxf's had to be scale down which caused quite a bit of editing and tweaking. So if you paln on doing small disc's then depending on the dxf you've found, (which I guess will have originated where mine came from or could even be my dxf's if 150mm because I did make them available along with the code) may have to do the same.?

[black5f]

Nice work Jonathan. What did you generate the code with?

Ian

Also interested in the details, how did you create the relief?

Tom