Thread: Definately a scrapyard challenge
Threaded View
-
04-01-2012 #6
So was I, and I am now though it's no longer there for strength. To start with that will be a limiting factor, but there's always the option to add a steel frame ... or even a simple rectangle on the bed made from steel box would help a lot.
That's why I mentioned you'll get better *acceleration* with 10mm pitch screws, and less vibration from the screw as it's not spinning so fast. I agree high rapid speeds are pretty much useless, but good acceleration is important. When I cut the mayan calender using lower aceleration values (as I was limited by the computer) than Jazz did added over an hour to the time it took. That's quite an extreme example admittedly, but the general trend is true.
Yes they will work fine, but not as well as could have been.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
BUILD LOG: Scrap Heap Challenge
By TrickyCNC in forum DIY Router Build LogsReplies: 38Last Post: 16-09-2012, 07:52 AM -
NEW MEMBER: Up for a challenge......
By swatt in forum New Member IntroductionsReplies: 1Last Post: 03-10-2010, 10:57 PM -
Fancy a challenge?
By cassius in forum Machine DiscussionReplies: 5Last Post: 03-09-2010, 02:44 PM
Bookmarks