Definately a scrapyard challenge

[motoxy]

Mr Routercnc That is an amazing spread sheet. okay I can now see box rules!! This was a previous design. I had the plate on which i mounted the rails and this was bolted to the box. The angle at the top and bottom get bolted to the plate and box as strengtheners. Is the angle more trouble that its worth? I cannot find where this was slated before so here is your opportunity. Piccy below.

Jazz i have a limited supply of 10mm plate, 50mm x 6mm angle and a length of 75 x 3.2 box. When i started I was going to make one of those plywood cnc m/c's. Wood I have plenty of. Trouble is you guys have shown me the error of my ways and I know that you are all prodding me in the right direction. Also As I said before this is a bench construction as I do not have access to a mill or c/lathe at the moment.

I can only ask you all to be patient. when you get close to 60 the old marbles fall away a bit.


Edit - Talked about in a pm but not actually slated..

Bruce