Definately a scrapyard challenge

[motoxy]

Wired up the spindle and did not blow it up. I have a link to youtube to prove it.

http://www.youtube.com/watch?v=C8bMG...ature=youtu.be

Bruce

[Jonathan]

Nice

It does always flash. Bear in mind if you run it in reverse without a cutter in but the collet nut on the nut has a tendency to fly off :naughty:

[motoxy]

Nice

It does always flash. Bear in mind if you run it in reverse without a cutter in but the collet nut on the nut has a tendency to fly off :naughty:

oops

How can you get the readout to give rpm?

Just doing a redraw to get some accurate drawings after all the sketching.
Bruce

[Jonathan]

How can you get the readout to give rpm?

Assuming you've set PD144 to 3000 you just keep pressing the >> button until you get to RPM.

I generally leave it set on current - much more interesting as you can see if the cut is drawing too much power.

[motoxy]

Thanks Jonathan. So glad I did not go down the kress route.