ok, first attempt using sketchup 8

[Jonathan]

20mm is a good size plate for the Z-axis.

The efficiency of ballscrews is roughly twice that of ACME screws, so it will be significantly faster. For the Aztec calender acceleration is much more important as it's lots of tiny moves. The bearing nut thingy you're using will make the difference slightly less. The main advantage is 5mm pitch versus 2mm pitch - the kinetic energy in the screw is significantly less if it's rotating 2.5 times slower.
The most accurate comparison you're going to get is comparing with my machine, as I sold you the screw. I got 6m/min with the screw your using and 42:13 pulleys on Y. I ran it at less than that with smaller pulleys as that was too close to the critical speed of the screw (see my build log for actual values). With 42:14 (I think) and a 10mm pitch ballscrew I got 60m/min. That's much more than you'll ever need so I've left it on close to 1:1 to get better resolution and acceleration.

[deannos]

20mm is a good size plate for the Z-axis.

The efficiency of ballscrews is roughly twice that of ACME screws, so it will be significantly faster. For the Aztec calender acceleration is much more important as it's lots of tiny moves. The bearing nut thingy you're using will make the difference slightly less. The main advantage is 5mm pitch versus 2mm pitch - the kinetic energy in the screw is significantly less if it's rotating 2.5 times slower.
The most accurate comparison you're going to get is comparing with my machine, as I sold you the screw. I got 6m/min with the screw your using and 42:13 pulleys on Y. I ran it at less than that with smaller pulleys as that was too close to the critical speed of the screw (see my build log for actual values). With 42:14 (I think) and a 10mm pitch ballscrew I got 60m/min. That's much more than you'll ever need so I've left it on close to 1:1 to get better resolution and acceleration.

Ok thanks Jonathan,

What is your thinking on using 10mm plate on the Y gantry, or would it be better using 20mm because of the length