Threaded View
-
24-01-2012 #1
Hi!
I am a complete novice on CNC-machines and has in fact never used one before. That being said I have for a long time wanted to make a desktop sized, cheap CNC-machine to learn the basics of how these work and might even make a few simple things with it (like milling PCB's, cutting thin metal sheets and such). I have therefore been googling a bit and looked at several DIY-projects. My main problem with most of the DIY-builds however are that they are too expensive for me (being a student means that money is a bit tight, sadly).
Being a complete dummy when it comes to electronics does not make things easier, since my biggest problem with this project is to figure out what electronics I need to drive my stepper motors and router. So far what I have managed to understand is that I will need driver boards for my steppers, as well as a breakout board so that I am able to interface the driver boards with my computer and the CAM/CAD software that I will be using.
I have found a driver board and a breakout board on Ebay, that seemed to fit the bill (for a low-cost as well):
Driver: http://www.ebay.co.uk/itm/L298N-Step...ht_5778wt_1163
Breakout board: http://www.ebay.co.uk/itm/CNC-5-Axis...#ht_6701wt_905
From my understanding I will need 3 of the driver boards a long with 3 stepper motors (have the motors from an old printer I scrapped) as well as a power supply, a router of some sort (dremel perhaps?) and of course the breakout board.
My questions are: "Will I be able to make a small desktop sized CNC using the above mentioned components?", and "Will the driver boards or the breakout board cause any compatibility problems with programs like Mach3?"
I hope my questions are understandable, and that you might be able to answer my questions. Thanks in advance!
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
3 wire stepper motor drivers?
By m_c in forum Stepper & Servo MotorsReplies: 0Last Post: 17-08-2013, 10:01 PM -
Setting up stepper motor drivers
By croy in forum Motor Drivers & ControllersReplies: 25Last Post: 30-09-2012, 09:51 PM -
Stepper motor advice for absolute novice
By mbgnjdb5 in forum Stepper & Servo MotorsReplies: 2Last Post: 07-05-2011, 04:47 PM -
Total novice and lost
By sfallan in forum Machine DiscussionReplies: 48Last Post: 10-09-2010, 10:35 AM -
eBay Stepper Motor Drivers from China
By Mad Professor in forum General ElectronicsReplies: 6Last Post: 20-07-2009, 10:54 PM
Bookmarks