-
26-01-2012 #1
Hi everyone,
I have a small chinese mill and a couple of days ago I rather pushed it beyond its limits. The motor got extremely hot and then everything shut
down causing an rcd in my fusebox to switch. Now whenever I try to switch my mill on it throws the rcd again. So I have either killed the motor,
(its a dc 600w type 91ZYT005) the controller board (JYMC 220B I) or the filter board. I can get spares, but the question is which of the
components is faulty and what tests can I run to find out? Bearing in mind that I am not an electrical engineer. Today I removed all the
electronic boards from their housing and inspected them but nothing looked burnt. I took photos of the connections before I undid all the
wiring.
Has anyone had a similar experice and solved it so could offer some advice or assistance. Does anyone know which component is most probably
affected and how I can check. Or should I just replace all three?
At present it is a manual mill, I was going to add steppers etc in the coming months but obviously now the priority is to fix the mill
so it runs again. However I am wondering how difficult it would be to replace the existing dc motor with a 3 phase ac one connected to an
inverter as an alternative, as this would allow me to control the speed automatically when I do complete the cnc conversion. It seems to me
that I just need to machine a housing to support the motor (how!! now mill not working). Has anyone any experience of doing that and can
offer some assistance?
Alan
Thread Information
Users Browsing this Thread
There are currently 2 users browsing this thread. (0 members and 2 guests)
Similar Threads
-
AC servo motor to replace a 3 phase induction motor on a mill spindle.
By rnr107 in forum Spindles & Drive MotorsReplies: 2Last Post: 23-04-2014, 03:14 PM -
bit of advice needed for first mill
By jmac80 in forum Milling Machines, Builds & ConversionsReplies: 9Last Post: 06-04-2014, 10:59 PM -
Z-Plunge advice sought...
By Wal in forum Machine DiscussionReplies: 3Last Post: 17-11-2013, 01:43 PM -
Advice Sought for Lathe
By Washout in forum Lathes, Lathe Rebuilding & ConversionsReplies: 13Last Post: 13-11-2013, 12:32 AM -
SPG X3 CNC Mill, advice needed please
By shaggyhawkings in forum Milling Machines, Builds & ConversionsReplies: 4Last Post: 07-01-2010, 11:00 PM
Bookmarks