5-axis Breakout Includes Hand-Held Control Port & 3,4,5-axis Postion-Display Port

[Jonathan]

having said that iv just ordered 6x 50v digital drivers for just over £160 and i'm hoping to see some improvements in speed and resonance.... with some luck i will be joining the the people that say the chinese TB6560 driver boards are a pile of steamy brown.... im not holding my breath though at £160

Why not 75-80V drivers ...you'll get a decent improvement but it could have been a lot more with the higher voltage.

edit: i cut plastics and a bit of alli on my machine so hi feed speeds are not required.... if your cutting wood you may not get to the ideal feed with a TB6560 board

Aluminium certainly doesn't need high feeds, but most plastics are easily cut at a pretty high feedrate. I've cut acetal at 5m/min which isn't hanging about!

[blackburn mark]

Why not 75-80V drivers ...you'll get a decent improvement but it could have been a lot more with the higher voltage

i was tempted but my machine is a small dumpy little thing (500mmx400mm ish cut) iv taken the punt in hope of bringing the noise down a bit when running it for hours (in a shared house)
the steppers make more noise (when they hit the resonance) than the spindle cutting acetal at 300mm
iv got to tiptoe between noise and speed :)

I've cut acetal at 5m/min which isn't hanging about!

shit! id make millions if i could run at that :)