Pre-RFQ Design

[JAZZCNC]

How much does the TV weigh?

Working on the fact the back piece is 500mm high then I don't think it's intended for portable or small TV.?

[Hutchie]

The bending is easy and could easily be done at home by using pre cut width's and clamping the material between 2 blocks of substantial wood then mending by hand and manipulating square/flat using flat block/mallet/ combo.

Not sure how you intend to mount/arrange this but if it's intended to free stand IE: Floor or Cabinet then Personaly as you have it designed then I don't think 200 x 6.75mm Ali is any where near strong enough to hold a TV.? . . . Would think about some gusseting or bracing.!

I just don't have the room to do it at the moment. Looking for a shop to do it for me. So, any recommendations?

Working on the fact the back piece is 500mm high then I don't think it's intended for portable or small TV.?

It is for a 37" TV, weighing 25lbs.

[JAZZCNC]

I just don't have the room to do it at the moment. Looking for a shop to do it for me. So, any recommendations?

No room required just a few clamps 2 blocks of wood and as been suggested an heat gun. . . . simplizzzz. 30min job