. .

Threaded View

Previous Post Previous Post   Next Post Next Post
  1. 25-03-2012 #14
    croy's Avatar
    Lives in Cardiff, United Kingdom.
    croy
    Last Activity: 26-09-2012 Has been a member for 9-10 years. Has a total post count of 29.
    Hi,


    Mach3 settings
    Steps per is 800, velocity 200, acceleration 74

    PM542 Controller settings
    microstep 8 which is 1600 usetps/rev
    4.2 Amps

    Quote Originally Posted by JAZZCNC View Post
    What settings are you set to at the minute.? both Acc and velocity please give micro steps drives set to as well.
    Last edited by croy; 25-03-2012 at 07:50 PM.
    Regards,
    Roy Stark
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 3 users browsing this thread. (0 members and 3 guests)

Similar Threads

  1. Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
    By craynerd in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 16-03-2014, 07:29 PM
  2. 3 wire stepper motor drivers?
    By m_c in forum Stepper & Servo Motors
    Replies: 0
    Last Post: 17-08-2013, 10:01 PM
  3. Purelogic featured stepper motor drivers PLD86 and PLD545.
    By Purelogic R&D in forum Manufacturer News
    Replies: 0
    Last Post: 07-06-2012, 08:36 AM
  4. Total novice seeks advice on stepper motor drivers
    By R.Andersen in forum Motor Drivers & Controllers
    Replies: 1
    Last Post: 25-01-2012, 11:34 AM
  5. eBay Stepper Motor Drivers from China
    By Mad Professor in forum General Electronics
    Replies: 6
    Last Post: 20-07-2009, 10:54 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules