Thread: Setting up stepper motor drivers
Threaded View
-
24-09-2012 #8
Last Activity: 17-03-2017
John,
The z-axis on a lathe is always a challenge. Have a look at this thread http://www.mycncuk.com/forums/lathe-...onversion.html to see one approach that should work on any lathe...
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Stepper Motor Driver - cheap similar to ArcEuro 4.2A Bi-Polar Stepper Motor Driver
By craynerd in forum Motor Drivers & ControllersReplies: 1Last Post: 16-03-2014, 07:29 PM -
3 wire stepper motor drivers?
By m_c in forum Stepper & Servo MotorsReplies: 0Last Post: 17-08-2013, 10:01 PM -
Purelogic featured stepper motor drivers PLD86 and PLD545.
By Purelogic R&D in forum Manufacturer NewsReplies: 0Last Post: 07-06-2012, 08:36 AM -
Total novice seeks advice on stepper motor drivers
By R.Andersen in forum Motor Drivers & ControllersReplies: 1Last Post: 25-01-2012, 11:34 AM -
eBay Stepper Motor Drivers from China
By Mad Professor in forum General ElectronicsReplies: 6Last Post: 20-07-2009, 10:54 PM
Bookmarks