Better finish

[luke11cnc]

I will cut two relief carvings today to see what is going on and post them later on today

James

[luke11cnc]

Thank you for the great idea about trying it higher or lower first I was so focussed on getting a good finish I never even thought of that Jazz
Not crying just frustrated

I'm cutting a set of clock hands out of corian later just for a change of scenery but I will come back to this problem after tea

James

[JAZZCNC]

James have you got to the bottom of this prob yet.?

[luke11cnc]

No yet but I did find a lose wire on my y-axis so I've re-soldered it and will try it again Tuesday

James

[luke11cnc]

Well I did as suggested and lowered my cutting bed by 20mm and recut my carving relief I also slowed down the finish pass to 360m/min and the results where the same.

my current velocity is set at 3000 and acceleration is set to 600

what would your next move be ??

James

[Musht]

Naive view from newbie alert.

Have you tried carving a similar but different relief?

Tried feeding the G-code through Cutview to see if its a mistake in the actual code?

http://www.cutviewer.co.uk

Cheers
Adam

[Musht]

Did you get to the bottom of this James?

Cheers
Adam

[luke11cnc]

Hello Adam

No not yet but still working on it and still hopeful I'm currently waiting on the results of the code being read to see if it's with in the G-Code also I think someone is cutting it on their machine to find out if it's also with in the G-Code

but thank you for the interest and keeping this post alive

James

[JAZZCNC]

I'm currently waiting on the results of the code being read to see if it's with in the G-Code also I think someone is cutting it on their machine to find out if it's also with in the G-Code

Not if you don't bloody send it won't.!!. . .:whistling:

[Jonathan]

Not if you don't bloody send it won't.!!. . .:whistling:

I thought that post was referring to me!