3 * RM1610 ballscrews, 780mm & 660mm

[JAZZCNC]

Chai did it, why do you ask just out of interest?

Because you shit on a lathe.. . .:rofl:. . . . . . .No Sorry actually would have been better to ask if you machined them to match the BK/BF blocks that's what I was asking for really.

With them having 25mm shaft then I wondered if you had done them for a special reason and none standard bearing block or self made design. No slur on your machineing prowess and would or will happly bought/buy them if you had machined them to match BK/BF blocks.

Edit: I've just emailed Chai to see if orders been sent or too late to cancel the screws so may be intouch.!

[Jonathan]

No, easier pulley alignment is the only reason so they'll fit BK/BF blocks. I wouldn't be caught dead with a BK/BF block anyway.

[Swarfing]

Jonathan just PM'd you

[JAZZCNC]

I wouldn't be caught dead with a BK/BF block anyway.

Nah now't wrong with them they just need a little TLC some times thats all, certainly can't make them any cheaper.! . . . Anyway I'll be using FK/FF blocks.!!