-
10-03-2012 #1
I have three new ballscrews to sell:2 of RM1610-780mm, 2 ballnut, end machining(F=25mm)1 of RM1610-660mm, 1 ballnut, end machining(F=25mm)They are end-machined in the normal fashion except the cylindrical portion has been made longer, 25mm, to accommodate fixing pulleys more easily.Will sell individually or as a lot, don't really care. Can cut to length and end machine if required.
Will consider all offers...also interested in exchanges for something good, like profile rails...Last edited by Jonathan; 30-09-2012 at 05:32 PM.
-
10-03-2012 #2
Shit Jonathan I've just ordered 2x800mm from Chai and these would have done the job. .!!!!!!!!!!!!!!! I'll see if he's sent them yet.
Did they come machined or did you do it.?
-
10-03-2012 #3
-
10-03-2012 #4
Because you shit on a lathe.. . .:rofl:. . . . . . .No Sorry actually would have been better to ask if you machined them to match the BK/BF blocks that's what I was asking for really.
With them having 25mm shaft then I wondered if you had done them for a special reason and none standard bearing block or self made design. No slur on your machineing prowess and would or will happly bought/buy them if you had machined them to match BK/BF blocks.
Edit: I've just emailed Chai to see if orders been sent or too late to cancel the screws so may be intouch.!
-
10-03-2012 #5
No, easier pulley alignment is the only reason so they'll fit BK/BF blocks. I wouldn't be caught dead with a BK/BF block anyway.
-
10-03-2012 #6
Jonathan just PM'd you
If the nagging gets really bad......Get a bigger shed:naughty:
-
10-03-2012 #7
-
10-03-2012 #8
Come on Jonathan are you holding out for Jazz to snap them up? :naughty:
If the nagging gets really bad......Get a bigger shed:naughty:
-
10-03-2012 #9
-
10-03-2012 #10
ha! ha! ha!
Think he is hoping for a fortune then?If the nagging gets really bad......Get a bigger shed:naughty:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Centec 2 ballscrews
By jonnydeen in forum Lead Screws, Nuts & SupportsReplies: 29Last Post: 11-07-2023, 09:53 AM -
Bended ballscrews. What i can do?
By ba99297 in forum Lead Screws, Nuts & SupportsReplies: 25Last Post: 13-04-2017, 01:41 PM -
Best place to get ballscrews?
By Ross77 in forum Lead Screws, Nuts & SupportsReplies: 6Last Post: 15-04-2013, 10:09 PM -
pictures of ballscrews??
By wilfy in forum Lead Screws, Nuts & SupportsReplies: 2Last Post: 28-10-2012, 09:09 PM -
FOR SALE: RM1610 ballscrews(used + 1605 x 900mm screw (new)
By rbs in forum Items For SaleReplies: 1Last Post: 10-05-2012, 08:23 PM
Bookmarks