George's 8x4 router-me-bob

[JAZZCNC]

Hi Jazz-

Not sure I explained myself very well-!!

Was defiantly using a rack and pinion on both x and y but a ball screw on z- but wanted To do a reduction from the steppers to the pinion gear-

Interested to hear of your sources-!


G

Doh.!! . . Yes I did read it wrong ok I under stand now.

Get drawing then give some more detail of motors,drives etc.

Are you planning on using 2 slaved motors to drive long Axis or a single motor driving shaft with pinion on each side.?