USB TO Parallel Port DIY Interface

[pavlo]

surely it would be easier to make a custom parallel cable to correct the pinouts rather than rewrite the code?

[sale030]

Hello to everybody.
I have one problem with my USB to PARALLEL Port DIY Interface. It's recognized correct on PC with Win XP but when I connect it to my laptop with Win 7/32 device has not recognized (Unknow device) as well as I connect it to my desktop PC with Win 7/64. Any sugestions?

[medet]

hello. can ı use thıs project with match3

[ComputerENGg]

Hello Sir.

sir im having trouble, which program do i need to use to control the leds? I have 8 LEDS in my project. I know how to control them using 8 PINS of the Parallel port and also using the Assembly language to create sequence of each LEDS/PINS., but what i want is, i want to control them using USB. Is this module that you have created can possibly control the LEDs?
I need your help sir. :(

Thanks a lot...
GodBless.

[pascalbianca]

Where can i download this beta from this thread?
http://www.mycncuk.com/forums/showth...ull=1#post1797

The link of the download is dead.
Thanks for the help.

[lkanta]

I did not see any connection of 5V and ground connection into the pcb design..
But in the schematic there is 5V and ground connection,
Any one please help me...

[irving2008]

I did not see any connection of 5V and ground connection into the pcb design..
But in the schematic there is 5V and ground connection,
Any one please help me...

see here: bottom two connections on right hand set of connectors.

[sacra]

Hi
I need to convert this parallel board to USB but the firmware codes aren't suitable for it. Each pin of the parallel port goes through a Fet directly to the a coil of a motor. It controls 2 unipolar stepper motors. As you say if one needs a diferent firmware you could change it and post it here, I kindly ask you to do so.I attach the board for your reference . Thanks

[markitosb]

hello good interface such a query to format or convert to gcode ga
I use vcarve 6.0 and then convert it from the software but it is frozen or has a special software to convert your answer gcode grasias por peru greetings

[mkydj]

you can customize for Mach3?