Denford EasyTurn Wanted - Boxford 125TCL & AUD Part ex.

**john legge** · 23-08-2012

just powered them both up after 5 years idle and the easiturn 3 is showing exceeded travel in the x axis , could this be something stuck as its been idle so long they were working correctly when last used ???

**rnr107** · 23-08-2012

Originally Posted by john legge

just powered them both up after 5 years idle and the easiturn 3 is showing exceeded travel in the x axis , could this be something stuck as its been idle so long they were working correctly when last used ???

Hi John,
What I was proposing to exchange was a Boxford AUD 5".
It is 3 phase, but has un inverter built in... And therefore runs of single phase.
It is one of the best manual lathe in its class I beleive... Run smooth.

With that and the potential problem on the easyturn in mind, I can do a direct swap if you are happy with that...
But I would need a few pictures.

Laurent