Boxford 125TCL Ugraded to Mch3 - fully working

[rnr107]

Laurent

How are you chap, i swapped this with you for the Sherline mill..

What did you do with the electronics?

Good look with sale, i would defiantly have this back if it were capable of bigger things

Yo! Cooliced!
I completely re-wired. Wiring was not good enough for me... found a few shorts here and there...
I also replaced the BOB and the spindle board. I could not get it to control the spindle under Mach3. Now the speed of the spindle is fully controlled by Mach3.
Also replaced the parallel cable, it is now properly solder to a connector. And replace the PC power supply with a proper one.

I'll post some pics as soon as I got time to flit it round and open the back... ;-)

PS: I had a lot of fun to take it from my upstairs bedroom to my ground floor workshop!


Laurent

[cooliced]

bet you did. hope your ok?

Looking forward to seeing the pics of the guts!

Good luck mate

[John S]

I'm very surprised this hasn't sold, must be some tight wads on here.

[rnr107]

I'm very surprised this hasn't sold, must be some tight wads on here.

LOL ! Well, I'll wait a bit longer and if it doesn't sell here I guess I'll have to pay eBay fees and put it there...

Laurent

[Jonathan]

if it doesn't sell here I guess I'll have to pay eBay fees and put it there...

eBay now have free listing weekends quite regularly - seemingly about every fortnight. Still going to get hit by the 10% final value fee though...

[rnr107]

Here are some pics of the electronic... Gecko drives!




As you can see, the door is resting on the bed of my AUD....

Laurent

[kptek99]

Laurent, PM sent

[John S]

I'd be sorely tempted but I have 3 CNC lathes already and this can't do any more than the ones I have. One thing in it's favour is that it's all working, only one of mine is, the other two need transplants.

[rnr107]

I'd be sorely tempted but I have 3 CNC lathes already and this can't do any more than the ones I have. One thing in it's favour is that it's all working, only one of mine is, the other two need transplants.

Hummm, I like this little CNC lathe... I'd love to keep it, just My problem is space.
I have 2.40m x 1.60m in there I have a Boxford AUD lathe, a Boxford 260VMC mill, a Boxford 125TCL lathe, a pillar drill and all tooling...
Basically I can just fit between all this standing straight... :-)

Laurent

[John S]

It's a priceless family heirloom