Quote Originally Posted by cooliced View Post
Laurent

How are you chap, i swapped this with you for the Sherline mill..

What did you do with the electronics?

Good look with sale, i would defiantly have this back if it were capable of bigger things
Yo! Cooliced!
I completely re-wired. Wiring was not good enough for me... found a few shorts here and there...
I also replaced the BOB and the spindle board. I could not get it to control the spindle under Mach3. Now the speed of the spindle is fully controlled by Mach3.
Also replaced the parallel cable, it is now properly solder to a connector. And replace the PC power supply with a proper one.

I'll post some pics as soon as I got time to flit it round and open the back... ;-)

PS: I had a lot of fun to take it from my upstairs bedroom to my ground floor workshop!


Laurent