. .

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 09-04-2012 #1
    John S's Avatar
    Lives in Nottingham, England, United Kingdom.
    John S
    Last Activity: 23-09-2017 Has been a member for 9-10 years. Has a total post count of 2,073. Received thanks 141 times, giving thanks to others 45 times. Referred 1 members to the community.
    Read the ZP5A setup instructions, they use for wierd pin layouts, not 23 for one axis, 45 for another.
    John S -
    Reply With Quote Reply With Quote

  2. The Following User Says Thank You to John S For This Useful Post:

    manofgresley
« Previous Thread | Next Thread »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. M542 driver - motor vibration at low speeds
    By birchy in forum Motor Drivers & Controllers
    Replies: 34
    Last Post: 22-11-2013, 08:16 PM
  2. M542 driver (Zapp) half or full current?
    By Smiler in forum Stepper & Servo Motors
    Replies: 9
    Last Post: 09-07-2013, 09:02 PM
  3. M542 problems see pictures
    By ciaranconlon in forum Motor Drivers & Controllers
    Replies: 18
    Last Post: 08-01-2013, 08:37 PM
  4. Stepper Driver / PSU / Breakout board Wiring ?
    By manofgresley in forum General Electronics
    Replies: 2
    Last Post: 16-08-2012, 05:41 PM
  5. M542 Driver
    By Swarfing in forum Motor Drivers & Controllers
    Replies: 28
    Last Post: 28-06-2012, 09:12 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules