-
09-04-2012 #1
hi there
had 3 of the TB6560 blue boards and kept blowin lumps out of the chips so decided to upgrade bought ZP5A-INT breakout board (5 axis)and 4 M542 stepper drivers of ebay
all wired up to a new nema23, NO GO
tried a nema 34 still NO go
my power supply is a 24V 12a
any ideas
i no i should of just got a new kit from ZAPP automation
-
09-04-2012 #2
Read the ZP5A setup instructions, they use for wierd pin layouts, not 23 for one axis, 45 for another.
John S -
-
The Following User Says Thank You to John S For This Useful Post:
-
09-04-2012 #3
-
The Following User Says Thank You to Ekfer For This Useful Post:
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
M542 driver - motor vibration at low speeds
By birchy in forum Motor Drivers & ControllersReplies: 34Last Post: 22-11-2013, 08:16 PM -
M542 driver (Zapp) half or full current?
By Smiler in forum Stepper & Servo MotorsReplies: 9Last Post: 09-07-2013, 09:02 PM -
M542 problems see pictures
By ciaranconlon in forum Motor Drivers & ControllersReplies: 18Last Post: 08-01-2013, 08:37 PM -
Stepper Driver / PSU / Breakout board Wiring ?
By manofgresley in forum General ElectronicsReplies: 2Last Post: 16-08-2012, 05:41 PM -
M542 Driver
By Swarfing in forum Motor Drivers & ControllersReplies: 28Last Post: 28-06-2012, 09:12 PM
Bookmarks