Hi All

Sorry for the long delay, but the company said to reinstall the pendant software to cure the tool height setter not working so not being too good at stuff like that, I left it until I had done all the jobs needed, (just in case I buggered it up) and reinstalled it as per the manual and it still did the same, as in your press the two buttons to start the automatic tool height setting and as before it jumps straight to the end without moving. However someone local who works with a cnc router said he didn't think it was a software problem as the pendant works fine with everything else, and the pendant thinks it's set the tool height when activated, so he thought it could be either a duff cable which for some unknown reason has shorted out (bearing in mind we still don't know what caused it to blow the power supply in the first place) and is sending a false signal to the tool height setter so it thinks it's set the height or a controller card problem.

So I contact the company to find out what the cable was as I can get one locally then take it back if it's not that before getting onto the controller card, but it seems the company is happy to sell you stuff, but when it comes to problems well it took them days to get back to me each time when I rung or e-mailed about the loss of power problem more times than not they never got back, and I had to re-contact them for an answer and now I don't even get a reply, to e-mails or when I ring get told he is not available.

So if anyone reads this that has the same controller pendant thingy as shown on the first page, if you know what the cable is that connects it up I would be grateful if you could let me know. It's going to be scsi or parallel, and did take it into the local pc world but the guy in there was clearly not on the same planet as the rest of us and just shrugged.

I have googled it but can't seem to find any mention of the cable used, and a chum said he thought it was a scsi cable, but wasn't sure. I cna post pics of the ends if that will help.

:) Don