View Poll Results: in which age group are you?
- Voters
- 237. You may not vote on this poll
-
under 21
8 3.38% -
21 - 30
31 13.08% -
31 - 40
34 14.35% -
41 - 50
64 27.00% -
51 - 60
53 22.36% -
over 60
42 17.72% -
Immortal soul of a shamen deity
5 2.11%
Threaded View
-
25-07-2012 #18
thanks for the interesting replies.. it's nice to see other peoples backgrounds.
jazz i will prove your over 35 rule wrong though... i'll ask every single question i can think of as i dont want to build a machine that i will be re-doing and replacing things on due to not listening or not asking.. hence my previous post about ballscrews.
i'm on quite a strict budget for my machine which i know i will bust, but if i can get 75% of the way and start having something to show for it i think my other half will forgive me for going over and let me spend the rest, my initial thoughts were to go for one of them mdf jobbies where you pay $25 for the plans, but through reading all your wonderfull threads and arguements ect, i've decided to ditch the mdf framing for alu extru more than likely and i've ditched the idea of threaded rod for ballscrews...
anyway back on topic, i didnt even consider that most people here would be those age group because i am used to being on a car audio forum where most people are sub 30's certainly sub 40's so i just presumed it would be the same here. i also had it in my head everyone would be small time hobby guys doing this to speed up and add accuracy and more complex shapes than could be achieved with a hand router.
Thread Information
Users Browsing this Thread
There are currently 4 users browsing this thread. (0 members and 4 guests)
Similar Threads
-
Feedback
By Jester in forum Stepper & Servo MotorsReplies: 1Last Post: 02-02-2014, 03:49 PM -
NEW MEMBER: Hello Group
By cambesol in forum New Member IntroductionsReplies: 4Last Post: 20-11-2013, 11:29 PM -
Feedback Poll - Do you like reciving the Newsletter ?
By Lee Roberts in forum General DiscussionReplies: 8Last Post: 24-12-2012, 06:34 PM -
Position feedback
By D.C. in forum Electronic Project BuildingReplies: 4Last Post: 17-10-2012, 11:30 AM -
Group Buy - End Mills?
By Tenson in forum Marketplace DiscussionReplies: 8Last Post: 18-05-2012, 09:23 PM
Bookmarks