3 Axis CNC router

[JAZZCNC]

Thanks for the patient explanation. Just so I'm clear are you saying 5-6m/min with 5mm or 10mm screws?

With 5mm pitch.

If I went with 2 as a starter I could see how it goes and swap out the screws in future... It's the only option which isn't insanely expensive!

This is why I'd go with the setup suggested. Easy to change up without costing the earth. If you make good job of alignment etc then you'll get 5-6mtr/min. Stick small ratio on and you'll get the speed up to point can cut most things.