3 Axis CNC router

[JAZZCNC]

Dean,
That would be very kind of you! About 400mm diameter would be good and I do use LinuxCNC. At that size I suspect a 60 degree cuter would produce a good result without going too deep but use 90 if you think otherwise, I have both.

Ok here you go. 90Deg cuts about 6mm deep and 60deg 10mm. It's set in MM's and used Arc's post processor so shouldn't be too jerky. My advice to speed up the job is lower the velocity and turn up the acceleration because the moves are very short, it also bounces around all over the place so don't be surprised. Enjoy

Edit: X Y zero is bottom left corner of 400mm square.