3 Axis CNC router

[JoeHarris]

Panel progress... estop working nicely (Despite temporarily shorting out the 24v supply and wondering what the squealing noise was..!)

[Lee Roberts]

Panel progress... estop working nicely (Despite temporarily shorting out the 24v supply and wondering what the squealing noise was..!)

Looks good, are you sure you've not done this before? Shorting out??? Do tell???

[JoeHarris]

Looks good, are you sure you've not done this before? Shorting out??? Do tell???

I connected the wires for the panel estop to the 24v fault indicator and the wires for the indicator to the estop meaning the 24 supply was just pumping current to itself. It took me a while to figure out what I had done wrong and it made a funny noise each time I switched it on to check if I had fixed it but it still seems to work! Whoops

[JoeHarris]

Looks good, are you sure you've not done this before? Shorting out??? Do tell???

Oh and no, never before but I am enjoying it! Been watching other peoples builds on this forum for years though...

[Lee Roberts]

Oh and no, never before but I am enjoying it! Been watching other peoples builds on this forum for years though...

Hehe I know that flavor!, good job it was only 24v then!