New CNC Mill on the horizon

[fvfdrums]

A decent amount of progress made on the frame this weekend, inspired by the build Jonathan did recently we decided to go down the route of a similar frame but at worktop height so working height of the bed is around 850mm at max settings. All made from 60x60x5mm, took plenty of time to weld up moving around the frame tacking then putting down some good welds so as not to distort.

End result is an extremely level frame in all directions (still will be doing resin but more to level out the bow in the cross section of the steel box section which is very noticeable along its length)

Still need to finish fully welding the frame as the bed is still only tacked but then X axis drive components next!