New CNC Mill on the horizon

[fvfdrums]

So got movement on y and z today :)

However need some assistance with the csmio board.

We have one digital input set up. Input 0 (pin 1. +ve, pin 14 -ve)

Feed runs from 24v supply through t3/l3 on contactor to pin 1, 24v present on pin 1 measured with MM.

And pin 14 connected to 24v -ve.

In Mach ports and pins estop is enabled, port #10 and PIN number 0 or 1 we have tried both and active high and low tried and with no combination of these can we get a response from Mach or an LED on the unit in either state

What are we doing wrong??

Other than that it's awesome to finally have some movement!!

[JAZZCNC]

Well you are connected correctly with right port and pins so Just has a test of the input try running 24V direct to pin 1 not thru contactor. It should light the Led on the controller. (you can also open plug-in to see active I/O state it's often easier)

[JAZZCNC]

What is the contact type NO or NC.! . . . . If NC then you want E-stop Pin active High and vise versa if NO.