Boxford Model B lathe rebuild

[rnr107]

Hi,
Yes, white primer on top of Red oxide is fine... Just mke sure they are of the same brand. I had a bubled paint problem painting different brands on top of each other.
If you want to paint white, you could use a High build primer on the top of the red oxide. (U-Pol High-5) these are beige almost white and are very thick, very good to hide the defects of the castings. And once fully dry, can be sand smooth (300 grit). I used it on the rough parts of the castings and got a pretty good finish after sending.

A couples of tip:
Get an angle grinder with a metal brush (You can get one fron 15 quids) a lot easier than a hand brush.
Lots of very light coats give a much better finish than 1 heavy one...

Are you going to spray or brush ?


RNR