few questions.

[John S]

I recently made a clutch lever for my motorbike, but the edges were quite sharp and uncomfortable. I want to be able to make the corners/edges curves. I'm guessing I would need a ball end mill and take lots of passes moving outward slowly to make it curved?

I'm use vcarve but I'm unsure as to how I could do it in that, if you could suggest some software that can do it or how to do it in vcarve then that would be great!

thanks :)

Do a second pass with a corner rounding cutter

[JAZZCNC]

Do a second pass with a corner rounding cutter

I think he'll want a more shaped lever John just rounding the corners will take the sharp edges off but motorbike levers are very shaped so guessing this is what he's after.?