Tool Height Setting Probe - Mach3 - solution

[HiltonSteve]

So basically what your saying is yes!

I did read that part of the manual but with not using this screen set before I was still unsure if it would work. Will give it a go later.

As for the £6.64, I will put it back in my pocket and go buy myself some banana's.

[JAZZCNC]

Opp's just re -read my reply and it comes over like was being OFF doesn't it which wasn't the case honest. . Soz if ya took it that way.!!

Yep dont do it personally but it reads has thou it's do-able. Easy to check thou without risking damage by Zeroing off the top of something soft has thou it was the bed, Then entering probe thickness and offset settings.!

Buy green Banana's they last longer.

[HiltonSteve]

Takes a lot more for me to take offense ..... anyway ... non taken!

Tried it, and it works perfectly.. Just what I was after .

Gerrys screenset is very good, looks nicer than the original, the functions on it are very impressive, only thing that niggles me is that it runs in a window and not full screen on my 1280 x 1024 monitor but I will get used to it.

[JAZZCNC]

Takes a lot more for me to take offense ..... anyway ... non taken!

Ok I'll try harder next time. .