Thread: Hi from east yorkshire
-
01-07-2012 #1
Evening members,
I’ve watched the forum for about 6 months now and come back for information and such like,
Little about me, hmmm im a young lad from East Yorkshire between York and Hull, Even at my age i have saved a nice capital amount of money to go and look at setting up as a cnc contractor, while prototyping/developing some items of my own that i have been drawing and planning for 2 or more years.
I’ve been helping/hindering/learning from a friend that runs a Haas tm3 and a tl1 as a hobbyist.
So with the Haas and other cnc experience I’ve gained running other machines, i have decided to setup offering cnc contracting in a range of fields.
Taken on a 1000sq unit local to me, my "plan" is to purchase a dmg mori seki lathe with a bar feed and a mill most likely from hurco/haas or if i can push for work then will consider a mill from dmg if the works there.
As per usual with everything its depending if i can source work for them (chicken and the egg!) if worse case it’s a no then im already a coded welder so will stick with light fabrication as a main rather than side job.
Think that’s a good enough introduction if not ask and answers will be posted.
Ben
-
01-07-2012 #2
Hi Ben
Welcome to the forum
Good luck with your new venture hope everything turns out ok for you.
Andy
-
02-07-2012 #3
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Hello from the south east!
By cncJim in forum New Member IntroductionsReplies: 5Last Post: 10-06-2013, 10:14 PM -
NEW MEMBER: Hello from East Sussex
By meyerga00 in forum New Member IntroductionsReplies: 2Last Post: 12-12-2010, 07:55 PM -
NEW MEMBER: Hi from Yorkshire
By Graham in forum New Member IntroductionsReplies: 4Last Post: 28-04-2009, 01:39 AM -
NEW MEMBER: Hello from Yorkshire
By potter1932 in forum New Member IntroductionsReplies: 1Last Post: 28-06-2008, 11:00 AM -
NEW MEMBER: NEW MEMBER FROM EAST YORKSHIRE
By shamus13 in forum New Member IntroductionsReplies: 6Last Post: 19-02-2008, 06:19 AM
Bookmarks