Well done, bravo.

My controller box has two big fat sockets on the side, one is the solenoid valves, the other goes to the temperature control box. Then there are about 6 cables coming in the bottom of the controller which are not unpluggable. First thing I did was add a piece of angle iron to the back of the box so I could hitch it slightly off the floor on the moulder table, that way I could pick the whole thing up and move it with a pallet truck.
Have you got a mould to put in it? I only ask because I don't and if you are going to set it up before I do then you can warn me about the pit falls

As far as I can tell my barrel has ABS in it which may be wet and rusty. I'm hoping the screw hasn't seized. I may disconnect it at the shear pin and try turning it by hand before I try turning it with the hydraulics.

Robin