Quote Originally Posted by Danielroyal25 View Post
You know you mention there may be issues with long jobs, what is the reason behind this.
I wanted the ability to slide large boards through the machine but may settle for turning them through 180 degrees instead.
From what I understand, long jobs are when you machine for 10+ hours without homing in between. Imagine one motor is losing a step here and there, and over a all those hours the missed steps could add up to a difference of a few mm's of one side of the gantry, taking it off square.

Homing would normally square it up again, but I'm not sure why on long jobs, like 3d carving, why can't you program a homing function every hour, and then continue where it left off.

Adil