Quote Originally Posted by wes5283 View Post
ok after you install the software you'll find the program ptp1000 in the c:\ drive. Or "c:\ptp1000 (should be an executable)

system auxiliary
f5 (configuration)
enter
enter
f1 system configuration
system options
which pc serial line
[ change it over to 2]
[you can use space bar to change]
[save]
[enter]
[esc]

f10
f3 (compilition)
use cntrl and + (keypad)
enter
list on "enter"
enter
esc

now retransmitt (this is done is the ptp driver)
after this the error will re-occur again.

Repeat this process (but change serial line to 1 this time)

this should solve the issue

thank you

wes thanks so much for this information it has worked for me only installed yeterday

i have one problem

i have two optima machines and because they are of different age the versions of ptp1000 are diferent one is 4.4g and other is 4.4l

with my new installation when the reer (eye) beam is broken the axis stop but the motor that is running dont stop.

Would it be possible for you to send me a copy of your ptp1000 installation so i can see if it would correct my problem


many thanks

john