Quote Originally Posted by D-man View Post
Hey Jazz, your "tutorial" worked perfectly!! Thanks a lot!!

However I have a couple questions.

The spindle is in the bed before it starts to spin. In other words it's the machine is doing the cycle and then the spindle comes to life - is the some sort of delay I could toggle with?

Emergency stop - when I hit the E/Stop the machine stops and there is also a delay on the spindle shutting Down, but perfect when I hit stop in Mach3. Any ideas?
Sounds like It will be the relay delay spinup/down settings inside Mach. Go to Ports & pins spindle setup and under the general parameters set the CW delay spinup = 0 or a low number like 1 same for CW spin down.

If that doesn't work then it's in the VFD settings but I'd ahve to go have a look at the manuel to find it.