-
21-12-2008 #1
As the title says...
I have so much I want to do...
Paint my mill stand
Fit its adjustable feet
Get the mill onto the stand and set it up
Pour a new rear bearing for the lathe
Make the Z-gantry for my PCB router/mill
Change the rear pads/discs on the car, get some new tyres and get it MOT'd
and a host more...
how much will i achieve...
I suspect very little....
-
21-12-2008 #2
Well, I was rather hoping to have a holiday, but I don't think it's going to happen. OTOH catching up a bit would be nice
-
23-12-2008 #3
Got to clear some space, just bought in injection moulder off ebay
Last edited by Robin Hewitt; 24-12-2008 at 11:08 AM.
-
23-12-2008 #4
-
23-12-2008 #5
Good luck with the good intentions to do stuff over the break - I'm planning on giving my workshop a big clearout, but strongly suspect that it will still be in the present untidy state at the end of the holiday.............
JeremyLast edited by Jeremy; 24-12-2008 at 12:12 PM.
-
23-12-2008 #6
Hi Irving
I built an extremely compact moulder because I didn't have the space for a big one.
I now have space. One of the basic rules of business is that that you always start from where you are now.
Here's a fun DIY injection mould link...
http://www.dms-diemould.co.uk/
And a fun finishing link...
http://www.caswelleurope.co.uk/index.htm
best
Robin
You and Jeremy, in the words of RoboCop, "Thank you for your co-operation"Last edited by Robin Hewitt; 24-12-2008 at 03:47 PM.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
NEW MEMBER: Designer with a plan looking for advice
By bigstu67 in forum New Member IntroductionsReplies: 2Last Post: 10-10-2012, 06:04 PM -
plan request connection card PCPPS
By ali hedi in forum General ElectronicsReplies: 2Last Post: 07-04-2010, 08:18 PM
Bookmarks